Power supply failure alarm

Most of the power supply failure indicator circuits need a separate power supply for themselves. But the alarm circuit presented here needs no additional supply source. It employs an electrolytic capacitor to store adequate charge, to feed power to the alarm circuit which sounds an alarm for a reasonable duration when the supply fails.
This circuit can be used as an alarm for power supplies in the range of 5V to 15V.
To calibrate the circuit, first connect the power supply (5 to 15V) then vary the potentiometer VR1 until the buzzer goes from on to off.
Whenever the supply fails, resistor R2 pulls the base of transistor low and saturates it, turning the buzzer ON.

Power supply failure alarm

About Ferhat Çelik

Elektronik mühendisliği için kitaplarla savaşan ve arası hiç iyi olmayan kişi. Kendi gibi elektronik ile ilgileneler için devre arşiv'i kuran Ferhat ÇELİK..

Check Also

Rain Alarm

This circuit gives out an alarm when its sensor is wetted by water. A 555 …

One comment

  1. Merhaba herkese web sitesi gerçekten dikkatimi çekti, twitter da paylaştım

Bir cevap yazın

E-posta hesabınız yayımlanmayacak. Gerekli alanlar * ile işaretlenmişlerdir

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Arduino